CCNA 200 301 IP Services

Question : 13 of 34

Marks: +1, -0

An engineer is configuring NAT to translate the source subnet of 10.10.0.0/24 to any one of three addresses: 192.168.3.1, 192.168.3.2, or 192.168.3.3. Which configuration should be used?

enable
configure terminal
ip nat pool my pool 192.168.3.1 192.168.3.3 prefix-length 30
access-list 1 permit 10.10.0.00.0.0.255
ip nat outside destination list 1 pool my pool
interface g 1/1
ip nat inside
interface g 1/2
ip nat outside
enable
configure terminal
ip nat pool my pool 192.168.3.1 192.168.3.3 prefix-length 30
access-list 1 permit 10.10.0.00.0.0.254
ip nat inside source list 1 pool my pool
interface g1/1
ip nat inside
interface g1/2
ip nat outside
enable
configure terminal
ip nat pool my pool 192.168.3.1192.168.3.3 prefix-length 30
route-map permit 10.10.0.0 255.255.255.0
ip nat outside destination list 1 pool my pool
interface g1/1
ip nat inside
interface g1/2
ip nat outside
enable
configure terminal
ip nat pool my pool 192.168.3.1192.168.3.3 prefix-length 30
access-list 1 permit 10.10 .0 .00 .0 .0 .255
ip nat inside source list 1 pool my pool
interface g1/1
ip nat inside
interface g1/2
ip nat outside

Validate

Go to Question:

Prev Question

Next Question